|
WELCOME TO CANADIAN MODEL LOCOMOTIVE WORKS
Finally I have broadband! I have been working out
of Abu Dhabi in the UAE for some time now and it is a great place.
However, until yesterday I only had a "Dial Up" connection in the apartment!
(Does anyone remember what that was like?) updates will now be more regular
and I apologize for the delays.
SD40-2W Page
CMLW is pleased to announce that we are now authorized dealers for DCC Specialties. DCC Specialties offers a full range of circuit breaker, signal processing, and stationary decoder products. Stay tuned for a new section for them! CMLW now offers BLMA products, as well as Bowser / Stewart! new web pages soon!
|
|
|
Wiring Aids
This is our lowest cost, easiest to use cab bus panel.
All four RJ-12 jacks are wired in parallel for easy plug and play
use. This board also provides a convenient point to add additional
12 Volt cab bus power, just plug in a 12 Volt "wall wart" power supply.
Shown with the included 1/16" thick aluminum, black anodized fascia
plate.
Recommended for large
club installations. This panel combines low cost with rugged DIN jacks
for long life. RJ-12 jacks provided on back for easy plug and play
installation. Solder holes also provided for high reliability hard
wired installation. Includes a 1/16" thick aluminum, black anodized
fascia plate.
The LED pack provides ten "Sunny White" LEDs. Size:
0.120" (3 mm) diameter. Rated at 3 to 20 mA.
Ten pack
of the NMRA eight-pin connectors used in many "DCC Ready" locomotives
and accessories.
UTP
UTP-Din
Plug Pack
LED Pack
The Sunny White LEDs that NCE offers
have a more realistic look. The loco on the left uses the usual bright
white/bluish LEDs, while the loco on the right shows a more natural
incandescent look of our LEDs.
UTP
UTP - DIN
LED Pack
Plug Pack
CMLW wishes to thank NCE
for sharing their product information and manuals with CMLW. All photos and
manuals are the property of NCE. All rights reserved
|
|
This website is the Copyright of CMLW All rights Reserved
|